What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 02.07.2025 01:11
In schematic diagrams this is the symbol for a fuse:
Here is a simplified AC power diagram.
[image of Common-mode choke]
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
so, what happens?
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
How to watch the 2025 Tony Awards - CNN
A circuit breaker is similar, but is resettable.
The other is “what does a “fuse” do?”
It seems Mohan does not understand the difference between a comment and an Answer.
World Aquatics Takes Tough Stance on Enhanced Games - Newser
[old diagram got deleted by accident]
A fuse is a non-resetable over current circuit protector.
eight
Trump slams Russia's Medvedev for claiming countries will give Iran nuclear warheads - CNBC
At least they know the answer if they wanted it.
Now when you have a certain ac resistance, then a current flows in a loop.
But it can get overloaded, and no longer works.
Jennifer Garner smooches boyfriend John Miller at charity event in rare PDA moment - Page Six
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
These are simplified answers to the original question, and does not change anything I wrote above.
For this case there are devices called Metal oxide varistors (MOV).
The #1 Spice to Help You Poop, According to Dietitians - EatingWell
He then describes Rainy Season and Lightning.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
2024–10–16 [ OO OLAOYE OYEBODE ]
What made you stop being an addict?
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
This is 'the assistant's answer'
Upvotes:
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
There are three different concepts here that are getting confused.
Pharmacy Mixes Up 9-Year-Old’s ADHD Medicine, Gives Him Opioid More Powerful Than Morphine - AOL.com
First Sentence:
nine
2024–10–10[John johnson John Johnson ]
What are Chinese hot pot restaurants? What do they serve, and why is it so popular in China?
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
I post the exact comment here.
(Dc diagram shown, AC is similar).
An AC voltage/ current source, and an ac inductive load.
Because the load is inductive, the current lags the voltage.(by a bit).
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
2024–10–14 [Omar Gharbi Omar Gharbi ]
So, the voltage could go up to 500 volts, and the fuse will not open up.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
a photo is worth a thousand words.
The third is lightning and “how it gets conducted into a home.”
He then describes the function of a fuse.
Edit 2024–10.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
the problem then depends on "how fast does the fuse operate?".
These devices are installed between the “hot” and “neutral” and protective ground.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
But… the neutral is now “floating” because of the 1 ohm resistance.
What is lightning?
This is where this question deviates from being a 'generic' question, and becomes more specific.
This is where the MOV conducts again, and dissipated the energy.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
What does a fuse do?
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
Barnstars:
One
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
There are two important concepts here.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
At one ohm, the resistor has a maximum of 1 watt power.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
The bolt then partially travels down the line to your home.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
The MOV will conduct when the voltage exceeds 50% of line voltage.
what exactly is a ‘surge’ protector?
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
This one hit behind the barn.
This device then solves the entire problem.
but this device (an Inductor) … impedes the rapid changes in the current.
but I think this circuit , shows a few more pieces.
He then asserts :
One is “what exactly is in a ‘surge protector’ ? ”
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
It also is a device that limits the change in current flow.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.